This error may occur because the disk type preset in the system installer does not match the original drive equipped inside the pc.
The default installation target type is NVMe PCIe, while the pc may come with a SATA SSD.
After receiving the installation failure prompt, manually select the disk type, format the drive, and restart system installation following the steps below:
- Set the SSD type to Disk (SATA).
- Check the option Format Disk only.
- Apply the settings. All data on the target disk will be erased.
- Uncheck Format Disk only, and select OneKeyRecovery installer.
- Apply the settings, then the device will commence system installation.
Comments
0 comments
Article is closed for comments.